How to automate Led Street Light assembly?

The cost of Led Street Light is high enough and the production speed is slow. Even if the cost can be reduced, it cannot replace the current energy-saving lamps and fluorescent lamps. It is very small, and it is difficult to mass-produce it according to the current situation, unless automation will speed up production. How to automate the assembly of Led Street Light  not only reduces the current variety, but also appropriately modifies the appearance of LED lights to meet the needs of automation. At present, the possibility of achieving full automation at one time is very low, but it can be automatically produced from the common appearance of each lamp type, such as lamp cap soldering, riveting and punching, and partial automation of inspection. This can be partially automated, and then do It is only possible to achieve the quantity and price required by the market through automation of the entire line.
Led Street lamps installation spacing and location:
According to the construction drawings and on-site geological investigation, in the place where there is no sunshade on the top of the street lamp, the installation position of the street lamp should be determined according to the distance between the street lamps of 20-50 meters, otherwise the installation position of the street lamp should be adjusted appropriately.
1. The width of the road is about 3-4 meters. The light pole is 3-4 meters. 15-20 watt LED lamp head, the installation distance should be 20-25 meters;
2. Road width is about 5-7 meters. 5-7 meters light pole. 30-50 watt LED lamp head, the installation distance should be 30-40 meters;
3. Road width is about 8-12 meters. 8-12 meters light pole. 50-120 watt LED lamp head, the installation distance should be 30-50 meters.

SUNLE LED Tunnel Lights SLS05
SLS05-15 50;3030(5050);56/28;1;4000k 130/150;＞70
SLS05-110;100;3030(5050);112/56;2;4000k;130/150;＞70