How should the installation points of factory lighting LED lamps be wired?

LED high bay light adopts ultra-bright LED chip as light source, adopts high-efficiency lens, adopts copper sheet for heat conduction and aluminum alloy sheet for heat dissipation, and fluid thermodynamic design makes the air circulate automatically for heat dissipation without noise, suitable for factories, mines, warehouses, petroleum , chemical industry, smelting and other enterprise units, especially suitable for lighting in flammable and explosive places, can use a variety of installation methods such as seat type and boom type.
LED high bay light performance advantages:.
1. Excellent explosion-proof performance, can be used safely in various flammable and explosive places.
2. It adopts LED chip led high bay light and optimized LED packaging structure to achieve the advantages of low light decay, high light efficiency, energy saving and environmental protection.
3. The key components of the power supply use world brands to ensure the service life of the lamps.
4. The crystal lens is used for light distribution to meet the lighting needs of different occasions.
5. Adopt transparent structure design, optimize heat dissipation structure, can ensure the life of lamps.
6. The lamp adopts an angle locking device, which can ensure that the long-term working angle does not change under the vibration environment.
7. The lamp body is made of light alloy material, with special sealing and surface coating, to ensure that the lamp will never corrode or rust in harsh environments such as humidity and high temperature.
If the factory has no other special operation requirements, the installation height of LED high bay lights should be less than 4 meters, which can improve lighting efficiency and reduce power consumption.
1. Experience in installing LED high bay lights:.
First, ensure that the LED factory light is good when you receive the goods. When you receive the led factory light, try to check the appearance of the led high bay light to see if it is damaged.
The second LED ceiling light is ready to be installed after arriving at the construction site. The manufacturer of the LED high bay light should first organize the installation personnel according to the installation drawings attached by the factory, and then connect a few LED ceiling lights to try the installation drawings. You can arrange for one person to test the lighting one by one, so as to avoid getting it upstairs and installing it, if it is broken, it needs to be removed.
The third is to remind the installer of the importance of fixing and wiring, especially the waterproofing of outdoor wiring is very important. It is best to review it when fixing and wiring.
Fourth, after the led high bay light is fixed and connected, it is best to use a multimeter on the main power supply to check whether the led high bay light is connected to the wrong wire and short circuit.
Fifth, after all the test lights are done, try to brighten them for as long as possible, and recheck them on the second day and the third day. After doing this, everything is good, and there will be no problems in the future.
2, the wiring method of led high bay light:.
Led high bay lights generally come out with three lines, the blue line and the brown line are connected to the live line and the neutral line, regardless of polarity, and there is a yellow line with a hint of green in the middle, the term is called yellow rolling green, this line The ground wire, if there is no ground wire coming, can be left blank.

SUNLE Waterproof Die-casting Aluminum LED High Bay Lights SLHBS6
Input voltage:AC 85V-265V
Frequency range:50HZ-60HZ
Power factor:＞0.95
Driver:SONSEN/SUNLE/DONE
LED quantity:120PCS 3030/180PCS 3030/240PCS 3030